1》When setting the cutter, you must first loosen the setting hand wheel and make the setting rod touch the cutting point control switch. Otherwise, when the cutter setting switch is turned ON, the set action cannot be generated.
2" When working, the cutter should be placed in the center of the upper pressure plate as far as possible to avoid unilateral wear of the machine and affect its life.
3》Replace with a new cutter. If the height is different, please reset it according to the setting method.

4》When cutting, please leave the cutter or chopping board with your hands. It is strictly forbidden to use your hands to help the die to cut, so as to avoid danger.
5》If the operator needs to leave the position temporarily, be sure to turn off the motor switch to avoid damage to the machine due to improper operation by others.
6》Please avoid overloading to avoid damaging the machine and reducing its service life.

Setting of the height of the cutter die of the cutting machine
1》Clear the debris on the rubber plate on the work surface, and place the knife mold in the center of the rubber plate.
2》After the machine is started, loosen the setting handwheel and turn the "pressure control" left to the zero position.
3》Turn the setting switch to the right of the "tool die setting" direction, and the cutting press plate 13 will begin to slowly descend until it is close to the die die and then automatically stops.
4》Push the setting handwheel to the bottom and tighten it. Before returning to start, set the switch system (left-handed) to the "cut" position.
5》Press the brake switch again, the cutting platen will immediately return to the highest position, and the cutter die setting is now complete.

Adjustment of cutting point of cutting machine
1》After the cutter die setting work is completed, put the material to be cut on the rubber sheet, then put the cutter die on the material, and then push the feed plate into the cutting area.
2》Press the 12 cutting switch with both hands, at this time, the cutting pressure plate will be lowered and pressurized on the die, and after the die cuts the material, it will automatically return to the position before starting and stop.
3》When cutting the material, if it is found that the material is not completely cut, adjust the 03 cutting depth controller to rotate the "pressure system" clockwise and counterclockwise; if the knife mold is pressed into the rubber sheet too deeply, the "pressure system" Rotate counterclockwise. The longer the adjustment time, the deeper the cutting depth. Try to adjust until the die is slightly pressed into the rubber sheet.
4》Pull the feeding plate out of the cutting area, take out the cut material, and complete a blanking process.